Home Center 2

Up Save Your House Rooms Devices Scenes Consumption Plugins Panels Events Configuration Logout

Dashboard:

Weather
Temp.: -
Humidity: -
Wind: -

Notifications

Notification

Create a message describing a device´s status. You can configure the message to be sent whenever the device changes state, or when it reaches a predetermined state.

Opera browser

The System doesn´t support Opera browser yet. Please use other browser, e.g. Firefox, Safari, Chrome, IE

Reload configuration

Alarm control panel device structure configuration in progress.

Backup

Backup description

Enter backup description

Start

Backup

Read carefully

Please wait whilst your backup is created. Once the backup has been created, it will appear under Configuration - Backups

Creating Backup 00 : 00

Backup takes ca. 30 seconds. In other case, please refresh the page.

Backup

Read carefully

Retrieving from backup. You will be notified when process is completed.

Restoring Backup 00 : 00

Retrieving from backup shouldn´t take more than 3 minutes. If not however, please refresh the page.

30s

Removing Devices

30s Delete Device

Learning Mode Active. To exit Learning Mode press STOP.

Automatic Z-wave chip backup after Removing Device.

Stop

Acess denied!

Reconfiguring Z-Wave network

Reconfiguring Z-Wave network. Devices are beeing reconfigured to new Home Center 2 software version. Current devices settings will be retained. Reconfiguration time depends on the number of devices within the network. Please wait.

Reconfiguring Z-Wave network. Please wait

Stop

Attention

Alarm

Information from Fibaro

Type PIN

Arm

Type PIN CODE

ago made tamper in device
in room

In N sensors detected tamper

Stop alarm